HP-UX Reference (11i v1 00/12) - 2 System Calls (vol 5)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man2/!!!intro.2
________________________________________________________________
___ ___
d
dup2(2) dup2(2)
NAME
dup2 - duplicate an open file descriptor to a specific slot
SYNOPSIS
#include <unistd.h>
int dup2(int fildes, int fildes2);
DESCRIPTION
fildes is a file descriptor obtained from a creat(), open(), dup(), fcntl(),or pipe() system call.
fildes2 is a non-negative integer less than the maximum value allowed for file descriptors.
dup2() causes fildes2 to refer to the same file as fildes.Iffildes2 refers to an already open file, the open
file is closed first.
The file descriptor returned by dup2() has the following in common with fildes:
• Same open file (or pipe).
• Same file pointer (that is, both file descriptors share one file pointer.)
• Same access mode (read, write or read/write).
• Same file status flags (see fcntl(2), F_DUPFD).
The new file descriptor is set to remain open across exec() system calls. See fcntl(2).
This routine is found in the C library. Programs using
dup2()
but not using other routines from the
Berkeley importability library (such as the routines described in bsdproc(3C)) should not give the
-lBSD
option to ld(1).
RETURN VALUE
Upon successful completion, dup2() returns the new file descriptor as a non-negative integer, fildes2.
Otherwise, it returns −1 and sets
errno to indicate the error.
ERRORS
dup2() fails if the following is true:
[EBADF] fildes is not a valid open file descriptor or fildes2 is not in the range of legal file descriptors.
[EINTR] An attempt to close fildes2 was interrupted by a signal. The file is still open.
SEE ALSO
close(2), creat(2), dup(2), exec(2), fcntl(2), open(2), pipe(2).
STANDARDS CONFORMANCE
dup2(): AES, SVID2, SVID3, XPG3, XPG4, FIPS 151-2, POSIX.1
Section 2−−50 − 1 − HP-UX Release 11i: December 2000
___
___