HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
u
ups_mond(1M) ups_mond(1M)
(Series 800 Only)
detectable.
UPS <
tty special file name> write failed: <errno>; ignoring that UPS.
UPS <
tty special file name> read of status received ILLEGAL CMD or NOISY
LINE.
UPS <
tty special file name> read of status received <number> bytes of unex-
pected data (octal: <
octal returned>): <string returned>.
UPS <
tty special file name> read of status failed: <errno>.
UPS <
tty special file name> write failed: <errno>.
UPS <
tty special file name> turned-off Failure Alarm.
UPS <
tty special file name> turned-off Inverter Failure Alarm.
UPS <
tty special file name> turned-off No Battery Alarm.
UPS <
tty special file name> turned-off Battery Charger Fault Alarm.
UPS <
tty special file name> turned-off Current Overload Alarm.
UPS <
tty special file name> turned-off High Ambient Temperature Alarm.
UPS <
tty special file name> turned-off Battery Failure Alarm.
UPS <
tty special file name> turned-off High Battery Voltage Alarm.
UPS <
tty special file name> turned-off Low Battery Voltage Alarm.
UPS <
tty special file name> turned-off High Output Voltage Alarm.
UPS <
tty special file name> turned-off Low Output Voltage Alarm.
UPS <
tty special file name> Inverter Failure requires repair.
UPS <
tty special file name> No Battery - ensure UPS battery installed.
UPS <
tty special file name> Battery Charger Fault- requires repair.
UPS <
tty special file name> Current Overload - either UPS bad or too many
devices connected.
UPS <
tty special file name> High Ambient Temperature- reduce area tempera-
ture.
UPS <
tty special file name> Battery Failure- requires repair.
UPS <
tty special file name> High Battery Voltage - requires repair.
UPS <
tty special file name> Low Battery Voltage - requires repair.
UPS <
tty special file name> UNKNOWN status/alarm <hex number> - may require
repair.
write to UPS <
tty special file name> of command <cmd string> Failed: <errno>.
read from UPS <
tty special file name> after sending command <cmd string> to
it failed; <
errno>.
UPS <
tty special file name> could not execute command <cmd string>; returned
(octal: <
octal returned>): <string returned> - possible bad signal cable.
Messages relating to Timer Controlled Power On and Off:
Timer Controlled On/Off information invalid; ignored.
mknod error: <
errno> for Timed On/Off fifo file /var/tmp/timed_off;
continuing without.
open error: <
errno> for Timed On/Off fifo file /var/tmp/timed_off;
continuing without.
Timer Controlled On value exceeds UPS <
tty special file name> maximum. The
maximum value of <
maximum supported decimal value> will be used for this
UPS.
Section 1M−−980 − 3 − HP-UX Release 11i: December 2000
___
___