HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
s
sysdef(1M) sysdef(1M)
NAME
sysdef - display system definition
SYNOPSIS
/usr/sbin/sysdef [kernel [master]]
DESCRIPTION
The command sysdef analyzes the currently running system and reports on its tunable configuration
parameters. kernel and master are not used, but can be specified for standards compliance.
For each configuration parameter, the following information is printed:
NAME The name and description of the parameter.
VALUE The current value of the parameter.
BOOT The value of the parameter at boot time, if different from the current value.
MIN The minimum allowed value of the parameter, if any.
MAX The maximum allowed value of the parameter, if any.
UNITS Where appropriate, the units by which the parameter is measured.
FLAGS Flags that further describe the parameter. The following flag is defined:
M Parameter can be modified without rebooting.
WARNINGS
Users of sysdef must not rely on the exact field widths and spacing of its output, as these will vary
depending on the system, the release of HP-UX, and the data to be displayed.
FILES
/usr/conf/master.d
Directory containing master files
Section 1M−−954 − 1 − HP-UX Release 11i: December 2000
___
___