HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)
__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
n
netfmt(1M) netfmt(1M)
axin bufs caselib caserouter
ip ipc lan loopback
netisr nfs nft ni
nsdiag nse probe pxp
rlbdaemon sockregd strlog tcp
timod tirdwr udp
event_list takes the form:
event_spec [,event_spec...]
where event_spec takes one of the three forms:
[!] integer [!]range [!]*
integer is an integer in hexadecimal (leading 0x), octal (leading 0), or decimal, which specifies a
log event for the subsystem indicated.
range takes the form integer-integer, and indicates an inclusive set of events.
X25 Naming and Filtering
The X25 product provides capabilities to assign symbolic names to important numbers and to filter log
events and trace messages. See x25log(1M) and x25trace(1M) for more information about X25 naming and
filtering.
OTS Filtering
The
OTS subsystem filter allows filtering of the message ID numbers that are typically found in the data
portion of an OTS subsystem’s log or trace record. The
OTS subsystem filter is effective for any subsystem
that is a member of the
OTS subsystem group.
OTS trace filtering configuration commands have the following form in config_file:
OTS [subsystem ] msgid [! ] message_ID *
Keywords and arguments are interpreted as follows:
OTS Identifies the filter as an OTS subsystem filter.
subsystem One of the following group of OTS subsystems:
OTS ACSE_PRES NETWORK
TRANSPORT SESSION
Note: The absence of subsystem implies that the filter applies to all OTS subsystems.
message_ID is the value of the message
ID to filter. A message ID is used by OTS
subsystems to
identify similar types of information. It can be recognized as a 4 digit number con-
tained in brackets (
[]) at the beginning of an OTS subsystem’s trace or log record.
Initially all message_IDs are enabled for formatting. To format records with specific
message_IDs, turn off all message
IDs using the !* operator, then selectively enable
the desired message IDs. Only one message_ID is allowed on each line. Multiple lines
are ‘‘OR’’ed together.
STREAMS Filtering
The STREAMS subsystem filter allows filtering on some fields of the messages logged by STREAMS
modules and drivers. See strlog(7) for more information.
EXTERNAL INFLUENCES
International Code Set Support
Single- and multi-byte character code sets are supported in data. Single-byte character codesets are sup-
ported in filenames.
DEPENDENCIES
netfmt only recognizes subsystems and filters from products which have been installed and configured.
WARNINGS
The syntax that was used for the obsolete LAN trace and log options has been mixed with the syntax for the
netfmt command such that any old options files can be used without any changes. The combination of
syntax introduces some redundancy and possible confusion. The global filtering options have the string
HP-UX Release 11i: December 2000 − 8 − Section 1M−−545
___
___