HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
s
swpackage(1M) swpackage(1M)
SD’s nonprivileged mode is intended only for managing applications that are specially
designed and packaged. This mode cannot be used to manage the HP-UX operating system
or patches to it. For a full explanation of nonprivileged SD, see the Software Distributor
Administration Guide, available at the http://docs.hp.com web site.
See also the admin_directory option.
software=
Defines the default software_selections. There is no supplied default. If there is more than
one software selection, they must be separated by spaces. Software is usually specified in a
software input file, as operands on the command line, or in the GUI.
source_file=psf
Defines the default location of the source product specification file (PSF). The host:path
syntax is not allowed, only a valid path can be specified. The -s option overrides this
value.
source_type=directory
Defines the default source type: cdrom, file, directory,ortape. The source type
derived from the -s option overrides this value.
targets=
Defines the default target_selections. There is no supplied default. If there is more than
one target selection, they must be separated by spaces. Targets are usually specified in a
target input file, as operands on the command line, or in the GUI.
uncompress_cmd=
Defines the command to uncompress files when installing, copying, or packaging. This
command processes files which were stored on the media in a compressed format. If the
compression_type of the file is
gzip then the internal uncompression (funzip)is
used instead of the external
uncompress_cmd
.
verbose=
Controls the verbosity of a non-interactive command’s output:
0 disablesoutput to stdout. (Error and warning messages are always written to stderr).
1 enables verbose messaging to stdout.
2 for swpackage and swmodify, enables very verbose messaging to stdout.
The -v option overrides this default if it is set to 0. Applies to all commands.
write_remote_files=false
Prevents file operations on remote (NFS) file systems. All files destined for packaging on
targets on a remote (NFS) file systems are skipped.
If set to true and if the superuser has write permission on the remote file system, the
remote files are not skipped.
Session File
Each invocation of the swpackage command defines a packaging session. The invocation options, source
information, software selections, and target hosts are saved before the installation or copy task actually
commences. This lets you re-execute the command even if the session ends before proper completion.
Each session is saved to the file $HOME/.sw/sessions/swpackage.last
. This file is overwritten
by each invocation of
swpackage.
You can also save session information to a specific file by executing
swpackage with the -C session__file
option.
A session file uses the same syntax as the defaults files. You can specify an absolute path for the session
file. If you do not specify a directory, the default location for a session file is
$HOME/.sw/sessions/
.
To re-execute a session file, specify the session file as the argument for the
-S session__file option of
swpackage.
Note that when you re-execute a session file, the values in the session file take precedence over values in
the system defaults file. Likewise, any command line options or parameters that you specify when you
invoke swpackage take precedence over the values in the session file.
Section 1M−−920 − 7 − HP-UX Release 11i: December 2000
___
___