HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
s
swinstall(1M) swinstall(1M)
(Hewlett-Packard Company)
the subproducts in the product) with a create_time less than or equal to the specified value
are available for selection (or autoselection). To list the create_time of bundles, products
and filesets, use:
swlist -a create_time -a create_date
customer_id=
This number, also printed on the Software Certificate, is used to "unlock" protected
software and restrict its installation to a specific site or owner. It is entered using the -x
customer_id= option or by using the Interactive User Interface. The customer_id can be
used on any HP-UX 10.0X or later system.
defer_configure=false
(Applies only to swinstall.) Causes swinstall to automatically run configure scripts
for the software_selections after they are installed. (Alternate root directories are not
configured.)
When set to true, swinstall does not run configure scripts. If you want to configure the
software later, you must run the swconfig command.
NOTES:
• Multiple versions of a product will not be automatically configured if another version is
already configured. Use the swconfig command to configure multiple versions
separately.
• SD ignores this option when it installs software that causes a system reboot.
distribution_source_directory=/var/spool/sw
Defines the default location of the source depot (when the source_type is directory).
You can also use the host
:path syntax. The -s option overrides this default.
distribution_target_directory=/var/spool/sw
(Applies only to swcopy.) Defines the default location of the target depot.
enforce_dependencies=true
Requires that all dependencies specified by the software_selections be resolved either in the
specified source, or at the target_selections themselves.
The
swinstall and swcopy commands will not proceed unless the dependencies have
also been selected or already exist at the target in the correct state (INSTALLED or AVAIL-
ABLE). This prevents unusable software from being installed on the system. It also
ensures that depots contain usable sets of software.
If set to false, dependencies are still checked, but not enforced. Corequisite dependen-
cies, if not enforced, may keep the selected software from working properly. Prerequisite
dependencies, if not enforced, may cause the installationor configuration to fail.
enforce_dsa=true
Prevents the command from proceeding past the analysis phase if the disk space required is
beyond the available free space of the impacted filesystem(s). If set to false, the install
or copy operation uses the filesystem’s minfree space and may fail because it reaches the
filesystem’s absolute limit.
enforce_kernbld_failure=true
(Applies only to swinstall.) Prevents swinstall from proceeding past the kernel
build phase if the kernel build processes fail. If set to
false, the install operation contin-
ues (without suspension if in the interactive mode) despite failure or warnings from either
the system preparation process or the kernel build process.
When set to the default value of true, this option generates an error if a command tries to
relocate a non-relocatable fileset. (Relocatable filesets are packaged with the
is_relocatable attribute set to true). When set to false, the usual error handling
process is overridden, and SD permits the command to relocate the fileset.
enforce_scripts=true
Controls the handling of errors generated by scripts. If true, and a script returns an
error, an error message appears reporting that the execution phase failed. If false,
swinstall attempts to continue operation. A warning message appears saying that the
analysis or execution phase succeeded. The message identifies the specific swinstall
Section 1M−−876 − 10 − HP-UX Release 11i: December 2000
___
___