HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
s
sam(1M) sam(1M)
Backup and Recovery
Interactively back up files to a valid backup device (cartridge tape, cartridge tape autochanger,
magnetic tape, DAT, magneto-optical disk, or magneto-optical disk autochanger). The SAM inter-
face is suspended so that you can read and/or respond to the interactive messages produced by
fbackup (see fbackup(1M)).
Recover files online from a valid backup device. The SAM interface is suspended so that you can
read/respond to the interactive messages produced by frecover (see frecover(1M)).
Add to, delete from, or view the automated backup schedule.
Obtain a list of files from a backup tape.
View various backup and recovery log files.
Disk and File Systems Management
Add, configure, or unconfigure disk devices, including hard drives, floppy drives, CD-ROMs,
magneto-optical devices and disk arrays.
Add, modify, or remove local file systems, or convert them to long file names.
Configure HFS or VxFS file systems.
Remote (NFS) file systems configuration, including:
Add, modify, or remove remote (NFS) file systems.
Allow or disallow access by remote systems to local file systems.
Modify RPC (Remote Procedure Call) services security.
Add, remove, or modify device or file system swap.
Change the primary swap device.
Add, modify, or remove dump devices.
Examine, create, extend, or reduce a volume-group pool of disks.
Create, extend or change number of mirrored copies of a logical volume and associated file system.
Remove a logical volume or increase its size.
Split or merge mirrored copies of a logical volume.
Share or unshare volume groups (only on ServiceGuard clusters running MC/LockManager distri-
buted lock-manager software).
Kernel and Device Configuration
Add/remove static drivers and DLKM modules to/from a kernel.
Modify static and dynamic tunable parameter values in the kernel.
Modify dump device configuration in the kernel.
Add or remove optional subsystems such as NFS, LAN, NS, CD-ROM, etc.
Generate a new kernel.
Networks/Communications
Configure one or more LAN cards.
Configure ARPA services.
Configure the Network File System (NFS).
Configure X.25 card or cards and PAD (Packet Assembler/Disassembler) services (if X.25 has been
purchased).
Peripheral Devices Management
Administer the LP spooler or Distributed Print Services and associated printers and plotters (see
"Printer and Plotter Management" below).
Add, modify, or remove the configuration of disk devices.
Section 1M752 2 HP-UX Release 11i: December 2000
___
___