HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
r
route(1M) route(1M)
Count Destination Type Flags Route Type
Route to a network directly from the local host=0 network U
Route to a network through a remote host gateway>0 network UG
Route to a remote host directly from the local host=0 host UH
Route to a remote host through a remote host gateway>0 host UGH
Wildcard route directly from the local host=0 default U
Wildcard route through a remote host gateway>0 default UG
DIAGNOSTICS
The following error diagnostics can be displayed:
add a route that already exists
The specified entry is already in the routing table.
delete a route that does not exist
The specified route was not in the routing table.
cannot update loopback route
Routes for any 127.*.*.* loopback destination cannot be added or deleted.
WARNINGS
Reciprocal route commands must be executed on the local host, the destination host, and all intermediate
hosts if routing is to succeed in the cases of virtual circuit connections or bidirectional datagram transfers.
The HP-UX implementation of route
does not presently support a change subcommand.
AUTHOR
route was developed by the University of California, Berkeley.
FILES
/etc/networks
/etc/hosts
SEE ALSO
netstat(1), ifconfig(1M), ping(1M), ndd(1M), getsockopt(2), recv(2), send(2), gethostent(3N), getnetent(3N),
inet(3N), routing(7).
HP-UX Release 11i: December 2000 − 3 − Section 1M−−731
___
___