HP-UX Reference (11i v1 00/12) - 1M System Administration Commands N-Z (vol 4)
__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/naaagt.1m
________________________________________________________________
___ ___
o
ocdebug(1M) ocdebug(1M)
NAME
ocdebug - outbound connection daemon debug utility used by DDFA software
SYNOPSIS
ocdebug -fpseudonym -nnode_name [-bboard_no][-cconfig_file][-ddebug_level ][-llog_level ]
[-pport_no ]
DESCRIPTION
The ocdebug daemon is the debugging version of the Outbound Connection Daemon (ocd). ocd is part
of the Data Communications and Terminal Controller (DTC) Device File Access (DDFA) software. It
manages the connection and data transfer to the remote terminal server port.
See ddfa(7) for more information on how to configure the DDFA software and for an explanation of how it
works.
Debugging may be toggled interactively by sending the SIGUSR1 signal to the process using:
kill -16 pid.
ocdebug logs important messages and error conditions to
/var/adm/syslog. Debug messages are
logged to the file
/var/adm/ocd pid and the file name is displayed at the start of debugging.
Options
ocdebug recognizes the following options. Apart from the -d option they are the same as the ocd
options.
-bboard_no Specify the board number of a DTC. If it is omitted, the port number option must
contain the full TCP service port address. The -b and -p options must not be used if
the IP address given in the -n option is the IP address of a port.
If the -n option explicitly names a terminal server port, the -b option is not needed.
-cconfig_file Specify the name (including the absolute path) of the configuration file used to profile
the terminal server port. If this value is omitted, the values specified in the default
pcf file (/usr/examples/ddfa/pcf
) are used. If the file specified does not
exist, an error message is logged and the following values are used (note that the
values for open_tries and open_timer are different from the default values):
telnet_mode: enable
timing_mark: enable
telnet_timer: 120
binary_mode: disable
open_tries: 0
open_timer: 0
close_timer: 0
status_request: disable
status_timer: 30
eight_bit: disable
tcp_nodelay: enable
-d
debug_level Specify the level of debugging. Levels can be added together to accumulate debugging
functions. For example, -d7 enables all levels and -d3 enables only the first two lev-
els. The levels are:
0 No debug messages.
1 Trace procedure entry/exit logged.
2 Additional tracking messages logged.
4 Data structures dumped.
-fpseudonym Specify the absolute or relative path to the device file, which is linked by the software
to the reserved pty. Applications use the pseudonym and not the dynamically allo-
cated pty slave.
-llog_level Specify the logging level. It determines the severity of messages sent to
/var/adm/syslog. The logging levels (and how they relate to system logging lev-
els) are as follows:
0 Log only LOG_CRIT messages.
HP-UX Release 11i: December 2000 − 1 − Section 1M−−609
___
___