HP-UX Reference (11i v1 00/12) - 1M System Administration Commands A-M (vol 3)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/!!!intro.1m
________________________________________________________________
___ ___
a
amutil(1M) amutil(1M)
amutil -F RACK_51
Stop flashing the amber LEDs on disk array RACK_51:
amutil -s RACK_51
The following example alters the rebuild priority settings. It assigns a value of 5 seconds to the rebuild
command rate, and sets the data block amount to 16 blocks on LUN 4 on disk array RACK_51. This gives
host I/Os higher priority than the default settings.
amutil -R 4 -f 50 -a 16 RACK_51
DEPENDENCIES
AM60Srvr must be running to execute this command. See AM60Srvr(1M).
AUTHOR
amutil was developed by HP.
SEE ALSO
ammgr(1M), amcfg(1M), amdsp(1M), amlog(1M), AM60Srvr(1M).
Section 1M40 3 HP-UX Release 11i: December 2000
___
___