HP-UX Reference (11i v1 00/12) - 1M System Administration Commands A-M (vol 3)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/!!!intro.1m
________________________________________________________________
___ ___
m
mksf(1M) mksf(1M)
-r -s Special File Name
yes no rdsk/ccardttargetddevice and
rfloppy/ccardttargetddevice
yes yes rdsk/ccardttargetddevicessection
no no dsk/ccardttargetddevice and
floppy/ccardttargetddevice
no yes dsk/ccardttargetddevicessection
hil
Note that only one of -a, -k,or-r is allowed.
-a address The link address (1-7).
-k Cooked keyboard.
-n The hil controller device.
special-file The default special file name depends on the -a, -k, and -r options:
Option Special File Name
-a hil_card.address
-k hilkbd_card
-r rhil_card
Note the underscore (_) before card. Also note that for card 0, each file will be linked
to a simpler name without
_card, either hiladdress, hilkbd,orrhil.
lan0 lan1 lan2 lan3
Note that only one of -e or -i is allowed.
-e Ethernet protocol.
-i IEEE 802.3 protocol.
-t Transparent mode (normally used by diagnostics).
special-file The default special file name depends on the -e, -i, and
-t options:
Option -t Special File Name
-e no ethercard
-e yes diag/ethercard
-i no lancard
-i yes diag/lancard
lantty0
-e
Exclusive access.
special-file The default special file name depends on whether the -e option is used:
-e Special File Name
no lanttycard
yes diag/lanttycard
lpr2 lpr3
-c
Capital letters. Convert all output to uppercase.
-e Eject page after paper-out recovery.
-n No form-feed.
-o Old paper-out behavior (abort job).
-r Raw.
-t Transparent mode (normally used by diagnostics).
-w No wait. Don’t retry errors on open.
special-file The default special file name depends on whether the -r option is used:
HP-UX Release 11i: December 2000 − 5 − Section 1M−−481
___
___