HP-UX Reference (11i v1 00/12) - 1M System Administration Commands A-M (vol 3)
__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/!!!intro.1m
________________________________________________________________
___ ___
l
lanadmin(1M) lanadmin(1M)
-s Display the current link speed setting of the interface corresponding to PPA.
-S speed Set the new link speed setting of the interface corresponding to PPA. You must
have superuser privileges.
-x options Get and display driver specific options of the interface corresponding to PPA.
-X options Set driver specific options of the interface corresponding to PPA. You must have
superuser privileges.
lanadmin recognizes the following Menu Mode options. They are ignored if they are given with an
Immediate Mode option.
-e Echo the input commands on the output device.
-t Suppress the display of the command menu before each command prompt. This
is equivalent to the Test Selection Mode terse command. The default is ver-
bose
.
Immediate Mode
In Immediate Mode, you can display the station address, source routing option, MTU size, and link speed of
LAN interface PPA. For certain interfaces, if you have superuser privileges you can also modify the station
address, source routing option, MTU size, and link speed. See "Options and Arguments" above.
Menu Mode
In Menu Mode, you can select an interface card, display statistics for the selected card, reset the card, and
clear the statistics registers.
Menu Mode accepts either complete command words or unique abbreviations, and no distinction is made
between uppercase and lowercase letters in commands. Multiple commands can be entered on one line if
they are separated by spaces, tabs, or commas.
Test Selection Mode Menu
This menu is entered when Menu Mode is first selected. The available Test Selection Mode commands are:
lan Select the LAN Interface Test Mode menu.
menu Display the Test Selection Mode command menu.
quit Terminate the lanadmin program.
terse Suppress the display of command menus.
verbose Restore the display of command menus.
LAN Interface Test Mode Menu
The following commands are available:
clear Clear the LAN interface network statistics registers to zero. You must have
superuser privileges.
display Display the RFC 1213 MIB II statistics. Depending on the link, the type-specific
MIB statistics may also be displayed. For instance, for Ethernet links, the RFC 1398
Ethernet-like statistics are displayed.
end Return lanadmin to Test Selection Mode.
menu Display the LAN Interface Test Mode command menu.
ppa Prompt for a PPA that corresponds to a LAN interface card. It defaults to the first
LAN interface encountered in an internal list. Appropriate values can be displayed
with the lanscan command (see lanscan(1M)).
quit Terminate the lanadmin program.
reset Reset the local LAN interface card, causing it to execute its self-test. Local access to
the network is interrupted during execution of reset. You must have superuser
privileges.
specific Display and execute commands from a driver specific menu.
HP-UX Release 11i: December 2000 − 2 − Section 1M−−401
___
___