HP-UX Reference (11i v1 00/12) - 1M System Administration Commands A-M (vol 3)
__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1m/!!!intro.1m
________________________________________________________________
___ ___
a
amcfg(1M) amcfg(1M)
RETURN VALUE
amcfg returns the following values:
0 Successful completion.
1 An error in execution (I/O, subsystem, security, etc.) occurred.
2 An error in command syntax occurred: for example, an unknown command-line option was
passed.
3 Timeout in communication to server. May indicate AM60Srvr is not running.
4 The state of the disk array has changed since AM60Srvr was started. A RESCAN should be
performed using amdsp(1M) to update AM60Srvr status.
DIAGNOSTICS
The following messages can be generated by amcfg:
Usage:amcfg { -L | -R } <CntrlrID>:<LUN>
-d <Channel:Id>[,<Channel:Id>...] -r <RAIDLevel>
[-c <Capacity>] [-s <SegmentSize>] [-force]
[-V] [-S] [-?] <ArrayID>
amcfg -C -d <Channel:Id>[,<Channel:Id>...]
-r <RAIDLevel> [-s <SegmentSize>]
[-V] [-S] [-?] <ArrayID>
amcfg -D <LUN> [-V] [-S] [-?] <ArrayID>
amcfg -M <LUN> -c <CntrlrID>
[-V] [-S] [-?] <ArrayID>
An error in command syntax has occurred. Re-enter the command with all necessary arguments.
amcfg: The <ArrayID> entered does not identify a known, supported array
The specified ArrayID does not exist or does not identify a device that is communicating with the sys-
tem. Verify the array exists and is operational.
amcfg: The specified controller is not physically installed.
A controller-specific command was issued to a non-existent or inaccessible controller.
amcfg: The specified LUN does not exist in this array.
The specified LUN does not exist.
amcfg: The capacity specified exceeds total available for disks.
LUN not created.
The capacity requested exceeds availablecapacity for the disks requested.
amcfg: Unknown capacity subscript: x
A capacity subscript of M or G was expected, or none at all. Found x instead. Re-enter command with
correct subscript.
amcfg: Capacity must be >= 10 MB
An attempt was made to create a LUN with a capacity less than 10 MB. A minimum size of 10 MB is
required. Re-issue the command with a larger capacity specification.
amcfg: LUN already owned by specified controller
An attempt was made to change the ownership of a LUN to the same controller that already owns it.
No operation is performed.
amcfg: LUN 0 may not be deleted. Use -R option to replace LUN 0
instead.
An attempt was made to delete LUN 0, which is not allowed. LUN 0 may, however, be reconfigured
using amcfg -R. No operation is performed.
amcfg: LUN’s owning controller not responding.
Check controller status or bind LUN to the other controller.
An attempt was made to bind a LUN to a controller which is not responding. No operation is per-
formed.
amcfg: LUN’s new owning controller not responding.
Check controller status or bind LUN to the other controller.
An attempt was made to replace (unbind and rebind) a LUN, but the new owning controller does not
respond. No operation is performed.
HP-UX Release 11i: December 2000 − 3 − Section 1M−−19
___
___