HP-UX Reference (11i v1 00/12) - 1M System Administration Commands A-M (vol 3)

ManualsBrandsHP ManualsSoftwareHP-UX Reference Manuals

241

242

243

244

245

246

247

248

249

250

__________________________________________________________________________________________________________________________________________________________________________________________________

STANDARD Printed by: Nora Chuang [nchuang] STANDARD

/build/1111/BRICK/man1m/!!!intro.1m

________________________________________________________________

___ ___

fcmsutil(1M) fcmsutil(1M)

clear_stat (TL)

This option is used to clear the statistics maintained by the driver. This option is supported

only by the TACHYON TL A5158A card.

nsstat (TL) This option is used to obtain detailed nameserver statistics maintained by the driver. This

option is supported only by the TACHYON TL A5158A card.

clear_nsstat (TL)

This option is used to clear the nameserver statistics maintained by the driver. This option

is supported only by the TACHYON TL A5158A card.

devstat (TL)

The devstat option is used to obtain detailed statistics associated with each AL_PA that

this AL_PA has communicated with.

If the remote-AL_PA is speciﬁed, then the statistics associated with that AL_PA are

displayed. If the all option is speciﬁed, statistics associated with all N_ports that the ini-

tiator has been able to communicate with, are displayed.

This option is supported only by the TACHYON TL A5158A card.

clear_devstat

(TL)

This option is used to clear the statistics associated with a target.

If the remote-AL_PA is speciﬁed, then the statistics associated with that AL_PA are cleared.

If the

all option is speciﬁed, statistics associated with all valid AL_PAs are cleared.

This option is supported only by the TACHYON TL A5158A card.

replace_dsk (TL)

This option is used to specify that no authentication should be performed the next time we

communicate with the device. This option is to be used by system administrators for replac-

ing a disk, with another (with the same N_Port_ID). Note that this is not required, if the

new disk acquires a new N_Port_ID.

This option is supported only by the TACHYON TL A5158A card.

disable WARNING: This is a DESTRUCTIVE test and communication to all nodes will be ter-

minated. The -f option can be used to suppress the warning message displayed by the

TACHYON TL A5158A card.

This option is used to disable a card, typically because of a hardware problem which cannot

be resolved and is interfering with system performance.

enable This option is used to enable a card, typically when a previous hardware problem has been

resolved.

EXAMPLES

Print the remote port parameters using the get remote option if the driver is idle. /dev/fcms1 is the

device ﬁle and /dev/rdsk/c27t0d0 is the respective raw disk ﬁle.

fcmsutil /dev/fcms1 get remote 0x98 < /dev/rdsk/c27t0d0

Print a short listing of the statistics maintainedby the driver, with /dev/td1

as the device ﬁle.

fcmsutil /dev/td1 stat -s

Send 5 echo packets of 200 bytes each to a remote AL_PA with loop_id 4, with

/dev/td1 as the device ﬁle

fcmsutil /dev/td1 echo -l 4 200 5

AUTHOR

/opt/fcms/bin/fcmsutil was developed by HP.

Section 1M−−222 − 4 − HP-UX Release 11i: December 2000

___