HP-UX Reference (11i v1 00/12) - 1M System Administration Commands A-M (vol 3)

ManualsBrandsHP ManualsSoftwareHP-UX Reference Manuals

191

192

193

194

195

196

197

198

199

200

__________________________________________________________________________________________________________________________________________________________________________________________________

STANDARD Printed by: Nora Chuang [nchuang] STANDARD

/build/1111/BRICK/man1m/!!!intro.1m

________________________________________________________________

___ ___

disksecn(1M) disksecn(1M)

(Series 800 Only)

size) used to create the etc/disktab ﬁle.

RETURN VALUE

disksecn returns the following values:

0 Successful completion.

1 Usage error.

2 User did not input parameters for an unknown disk.

3 Disk too small or an invalid block size.

disksecn aborts and prints an error message under the following conditions:

• disksecn was invoked without specifying a disk name.

• Requested both -p and -d switch.

• Illegal block size requested.

• Unknown disk name was speciﬁed and user did not supply disk information.

• Disk’s maximum storage space is less than approximately 44 MB.

WARNINGS

Alternate names are not included in the output when the -d switch is used.

Blanks are required in the command line between each of the switches when invoking disksecn.

A blank is required between the -n switch and the disk name argument to that switch. For example:

disksecn -p -b 1024 -n hp9712

disksecn does not save the block size used to generate the /etc/disktab disk description ﬁle. The system

assumes that the block size used was

DEV_BSIZE when it reads the information stored in the etc/disktab

ﬁle.

AUTHOR

disksecn was developed by the University of California, Berkeley.

FILES

/etc/disktab