HP-UX Reference (11i v1 00/12) - 1 User Commands N-Z (vol 2)

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1/neqn.1
________________________________________________________________
___ ___
t
tsm.command(1) tsm.command(1)
NAME
tsm.command - send commands to the Terminal Session Manager(TSM)
SYNOPSIS
/usr/tsm/bin/tsm.command command
DESCRIPTION
tsm.command is used to send a command string programmaticly to the Terminal Session Manager (TSM),
as if the string were typed on the TSM command line. tsm.command fails unless it is run from inside a
TSM session. Actions caused by tsm.command affect only the instance of TSM that tsm.command is
run under. command can have any value that is a valid key sequence for the TSM command line. The
sequence should not include the "hotkey" character that normally initiates the command line mode of TSM.
The sequence should end at the point where TSM exits command mode. If it ends prematurely TSM behaves
as though escape was pressed, which exits command mode, usually canceling the command. \r should be
used to indicate a return key. If no arguments are given on the command line, the program prompts for
input from the user. If a ˆC terminates the sequence, the remainder of the sequence is accepted from the
user.
AUTHOR
tsm.command was developed by Structured Software Solutions, Inc.
SEE ALSO
tsm(1).
HP-UX Release 11i: December 2000 − 1 − Section 1−−951
___
___