HP-UX Reference (11i v1 00/12) - 1 User Commands A-M (vol 1)
__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1/!!!intro.1
________________________________________________________________
___ ___
i
iostat(1) iostat(1)
NAME
iostat - report I/O statistics
SYNOPSIS
iostat [-t][interval [count ]]
DESCRIPTION
iostat iteratively reports I/O statistics for each active disk on the system. Disk data is arranged in a
four-column format:
Column Heading Interpretation
device Device name
bps Kilobytes transferred per second
sps Number of seeks per second
msps Milliseconds per average seek
If two or more disks are present, data is presented on successive lines for each disk.
To compute this information, seeks, data transfer completions, and the number of words transferred are
counted for each disk. Also, the state of each disk is examined
HZ times per second (as defined in
<
sys/param.h >) and a tally is made if the disk is active. These numbers can be combined with the
transfer rates of each device to determine average seek times for each device.
With the advent of new disk technologies, such as data striping, where a single data transfer is spread
across several disks, the number of milliseconds per average seek becomes impossible to compute accu-
rately. At best it is only an approximation, varying greatly, based on several dynamic system conditions.
For this reason and to maintainbackward compatibility, the milliseconds per average seek (
msps ) field is
set to the value 1.0.
Options
iostat recognizes the following options and command-line arguments:
-t Report terminal statistics as well as disk statistics. Terminal statistics include:
tin Number of characters read from terminals.
tout Number of characters written to terminals.
us Percentage of time system (active processors) has spent in user mode.
ni Percentage of time system (active processors) has spent in user mode run-
ning low-priority (nice) processes.
sy Percentage of time system (active processors) has spent in system mode.
id Percentage of time system (active processors) has spent idling.
interval Display successive lines which are summaries of the last interval seconds. The first line
reported is for the time since a reboot and each subsequent line is for the last interval
only.
count Repeat the statistics count times.
EXAMPLES
Show current I/O statistics for all disks:
iostat
DisplayI/O statistics for all disks every 10 seconds untilINTERRUPT or QUIT is pressed:
iostat 10
DisplayI/O statistics for all disks every 10 seconds and terminate after 5 successive readings:
iostat 10 5
Display I/O statistics for all disks every 10 seconds, also show terminal and processor statistics, and ter-
minate after 5 successive readings:
iostat -t 10 5
WARNINGS
Users of iostat must not rely on the exact field widths and spacing of its output, as these will vary
depending on the system, the release of HP-UX, and the data to be displayed.
Section 1−−358 − 1 − HP-UX Release 11i: December 2000
___
___