Red Hat Directory Server 8.0 Configuration, Command, and File Reference

Parameter Description

Default Value 300000

Syntax DirectoryString

Example nsslapd-outbound-ldap-io-timeout: 300000

3.1.71. nsslapd-plug-in

This read-only attribute lists the DNs of the plug-in entries for the syntax and matching rule

plug-ins loaded by the server.

3.1.72. nsslapd-port (Port Number)

This attribute gives the TCP/IP port number used for standard LDAP communications. To run

SSL/TLS over this port, use the Start TLS extended operation. This selected port must be

unique on the host system; make sure no other application is attempting to use the same port

number. Specifying a port number of less than 1024 means the Directory Server has to be

started as root.

The server sets its uid to the nsslapd-localuser value after startup. When changing the port

number for a configuration directory, the corresponding server instance entry in the

configuration directory must be updated.

The server has to be restarted for the port number change to be taken into account.

Parameter Description

Entry DN cn=config

Valid Range

1 to 65535

Default Value 389

Syntax Integer

Example nsslapd-port: 389

NOTE

Set the port number to zero (0) to disable the LDAP port if the LDAPS port is

enabled.

3.1.73. nsslapd-privatenamespaces

This read-only attribute contains the list of the private naming contexts cn=config, cn=schema,

and cn=monitor.

Chapter 2. Core Server Configuration Reference