HP PRM Version C.03.06 release notes - (March 2012)

8. Configure PRM GUI and restart HP System Management Homepage (SMH).
NOTE: This step assumes SMH is already installed. If not, install SMH before completing
this step. (As of May 2005, SMH is available from the Applications DVD and the Operating
Environment DVD. It is also available at http://www.hp.com/go/softwaredepot.)
If you are going to use PRM’s interface available through SMH, perform the following steps:
a. Configure the PRM interface by running:
# /opt/prm/bin/prmsmhconfig -c
b. Restart SMH.
You can now access the PRM interface in SMH through the following links:
Tools→Resource Management→Manage PRM Groups
9. Restart WLM if it was running before the PRM upgrade/installation:
# /opt/wlm/bin/wlmd -A
10. Restart MeasureWare if it was running before the PRM upgrade/installation:
# /sbin/init.d/mwa start
PRM is installed in /opt/prm/. PRM manpages are also installed in /opt/prm/.
NOTE: If you have made any modifications to your /etc/rc.config.d/prm file and the
corresponding file being shipped with the PRM being installed has changed, the file
/var/adm/sw/swagent.log will note a conflict. If there is a conflict, merge the file
/usr/newconfig/etc/rc.config.d/prm with your /etc/rc.config.d/prm file. Changes in the file
shipped with PRM are due to the introduction of new variables or changes in the default values
for existing variables.
Starting with PRM C.02.01, the /usr/newconfig/etc/rc.config.d/prm file includes several new
variables: PRM_CONFIG_FILE, PRM_INT_APPL, PRM_INT_MEM, PRM_LOG_APPL, and
PRM_LOG_MEM.
Installation procedure for PRMSIMTools
Install the bundle PRMSIMTools on systems that already have HP Systems Insight Manager (SIM)
installed and from which you want to control or monitor PRM.
If you want to control resources on the local system, install the full PRM product, B3835DA, as
explained in the section “Installation procedure for B3835DA” (page 10).
To install the PRMSIMTools bundle:
1. Start the SD-UX swinstall command. It will invoke a user interface to lead you through the
installation.
2. Load product PRMSIMTools.
Installation procedures 11