HP PRM Version C.03.06 Release Notes HP-UX 11i v2 and HP-UX 11i v3 (B3835-90030, June 2013)

Workaround To ensure that WLM works properly on a system with PRM C.03.04 or later,
upgrade WLM to A.03.02 or later. When upgrading from WLM A.03.00 or
earlier, upgrade WLM prior to upgrading PRM.
prm2d dumps negative values in the syslog, though real memory pages
are available
Issue If you install PRM C.03.06, prm2d might dump negative values in the syslog
(even when real memory pages are available), if the system is under memory
pressure. The CR QXCR1001103447, which is related to this issue, where negative
values were seen in the prmavail output too, is fixed in PRM C.03.06.
Workaround Verify whether the output of the prmavail command shows the correct
(non-negative) value for real memory pages. Ignore the syslog output for the
prmavail command.
prmconfig dumps core when kernel parameter nrpoc is changed online
Issue If you increase the kernel parameter nproc online to a value above 4200 on a
system running HP-UX 11 v3, and you do not reboot the system, the prmconfig
command might dump core.
Workaround Reboot the system.
16 Known problems and workarounds