HP PRM Version C.03.05 Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

9. Restart WLM if it was running before the PRM upgrade/installation:
# /opt/wlm/bin/wlmd -A
10. Restart MeasureWare if it was running before the PRM upgrade/installation:
# /sbin/init.d/mwa start
PRM is installed in /opt/prm/. PRM manpages are also installed in /opt/prm/.
NOTE: If you have made any modifications to your /etc/rc.config.d/prm file and the
corresponding file being shipped with the PRM being installed has changed, the file
/var/adm/sw/swagent.log will note a conflict. If there is a conflict, merge the file
/usr/newconfig/etc/rc.config.d/prm with your /etc/rc.config.d/prm file. Changes in the file shipped
with PRM are due to the introduction of new variables or changes in the default values for
existing variables.
Starting with PRM C.02.01, the /usr/newconfig/etc/rc.config.d/prm file includes several new
variables: PRM_CONFIG_FILE, PRM_INT_APPL, PRM_INT_MEM, PRM_LOG_APPL, and
PRM_LOG_MEM.
Installation procedure for PRMSIMTools
Install the bundle PRMSIMTools on systems that already have HP Systems Insight Manager
(SIM) installed and from which you want to control or monitor PRM. If you want to control
resources on the local system, install the full PRM product, B3835DA, as explained in the section
“Installation procedure for B3835DA” (page 12).
To install your software:
1. Start the SD-UX swinstall command. It will invoke a user interface to lead you through
the installation.
2. Load product PRMSIMTools.
3. Configure the PRM GUI for HP Systems Insight Manager (SIM)
NOTE: This step assumes SIM is already installed. If not, install SIM before completing
this step. (SIM is available from the Applications DVD and the Operating Environment
DVD. It is also available at http://www.hp.com/go/softwaredepot.)
If HP VSE Management Software A.03.00.00 or later is not installed If you do not have HP
Virtual Server Environment Management Software A.03.00.00 or later installed, run the
following command to configure the PRM GUI:
# /opt/prm/bin/prminitconfig -a
If HP VSE Management Software A.03.00.00 or later is installed If you installed HP Virtual
Server Environment Management Software A.03.00.00 or later and ran vseinitconfig
-a, it ran prminitconfig -a for you.
When you log in to HP Systems Insight Manager by pointing your web browser to:
http://SIM_host:280
where SIM_host has SIM and now PRMSIMTools installed, you can now access the PRM
interface through the following links:
Optimize→Process Resource Manager→Manage PRM Groups
Required patches
The patches needed to use PRM Version C.03.05 are discussed below.
For the latest information on patches, visit the “patches” page available at
Required patches 13