HP PRM Version C.03.04 Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

PRM Release Notes
Compatibility information and installation requirements
Chapter 110
Step 9. Restart WLM if it was running before the PRM upgrade/installation:
# /opt/wlm/bin/wlmd -A
Step 10. Restart MeasureWare if it was running before the PRM upgrade/installation:
# /sbin/init.d/mwa start
PRM is installed in /opt/prm/. PRM manpages are also installed in /opt/prm/.
NOTE If you have made any modifications to your /etc/rc.config.d/prm file and the
corresponding file being shipped with the PRM being installed has changed, the
file /var/adm/sw/swagent.log will note a conflict. If there is a conflict, merge the
file /usr/newconfig/etc/rc.config.d/prm with your /etc/rc.config.d/prm file.
Changes in the file shipped with PRM are due to the introduction of new
variables or changes in the default values for existing variables.
Starting with PRM C.02.01, the /usr/newconfig/etc/rc.config.d/prm file includes
several new variables: PRM_CONFIG_FILE, PRM_INT_APPL, PRM_INT_MEM,
PRM_LOG_APPL, and PRM_LOG_MEM.
Installation procedure for PRMSIMTools
Install the bundle PRMSIMTools on systems that already have HP Systems Insight Manager
(SIM) installed and from which you want to control or monitor PRM. If you want to control
resources on the local system, install the full PRM product, B3835DA, as explained in the
section “Installation procedure for B3835DA” on page 8.
To install your software:
Step 1. Start the SD-UX swinstall command. It will invoke a user interface to lead you
through the installation.
Step 2. Load product PRMSIMTools.