HP PRM Version C.03.03.01 Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

PRM Release Notes
Compatibility information and installation requirements
Chapter 1 11
Step 3. Configure the PRM GUI for HP Systems Insight Manager (SIM)
NOTE This step assumes SIM is already installed. If not, install SIM before
completing this step. (SIM is available from the Applications DVD
and the Operating Environment DVD. It is also available from
http://www.hp.com/go/softwaredepot.)
If HP VSE Management Software A.03.00.00 or later is not installed
If you do not have HP Virtual Server Environment Management Software
A.03.00.00 or later installed, run the following command to configure the PRM GUI:
# /opt/prm/bin/prminitconfig -a
If HP VSE Management Software A.03.00.00 or later is installed
If you installed HP Virtual Server Environment Management Software A.03.00.00
or later and ran vseinitconfig -a, it ran prminitconfig -a for you.
When you log in to HP Systems Insight Manager by pointing your web browser to:
http://SIM_host:280
where SIM_host has SIM and now PRMSIMTools installed, you can now access the PRM
interface through the following links:
Optimize
-> Process Resource Manager -> Manage PRM Groups
Required patches
The patches needed to use PRM Version C.03.03.01 are discussed below.
For the latest information on patches, visit the “patches” page available from
http://www.hp.com/go/prm/.
The patches below—or their successors—may be available in patch bundles. Obtain patches
and patch bundles from http://itrc.hp.com or from the quarterly HP-UX software update
release CDs.