HP PRM Version C.03.02.xx Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

PRM Release Notes
Known problems and workarounds
Chapter 124
Workaround
Be sure your applications that access the network bind only to sockets on
the virtual network interface created for their respective secure
compartments.
For more information, see the Security Containment release notes and the
HP-UX 11i Security Containment Administrator’s Guide.
Network Node Manager and PRM’s SNMP structures
Issue
When you install the OpenView products after installing PRM, the
OpenView networking products, including Network Node Manager, do not
recognize PRM’s SNMP structures.
Workaround
Run the following command:
# /opt/OV/bin/xnmloadmib -load /opt/prm/prm.my -replace
This command is automatically run when you install PRM and when you
boot the system.
prmavail not showing VxVM disk groups
Issue
On HP-UX 11i v1 (B.11.11) and HP-UX 11i v2 (B.11.23), if you are logged in
as a nonroot user, invoking the prmavail command does not display
information for VxVM disk groups.
Workaround
This issue is due to a permissions problem. Change permissions as shown
below:
# chmod 755 /dev/vx
If you are interested in the status of this issue, contact your HP support
representative regarding CR# JAGae90306 (for HP-UX 11i v1) or
CR# JAGae73866 (for HP-UX 11i v2).