HP PRM Version C.03.02.xx Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

PRM Release Notes
Compatibility information and installation requirements
Chapter 1 17
Compatibility with gWLM
PRM and HP Global Workload Manager (gWLM) should not be used to manage the same
system at the same time. Using these products to control resources at the same time may
cause inconsistent behavior and undesirable performance.
Compatibility with long hostnames
PRM supports long hostnames. You must install the bundle NodeHostNameXpnd and
configure the feature first though. For more information, see the section “Installation
procedure” on page 10.
Compatibility with online cell operations
If you want to perform online cell operations, and:
• Your PRM configuration contains memory records
Stop memory management (prmconfig -d MEM), then after the online cell operation has
completed, restart memory management (prmconfig -e MEM).
• Your PRM configuration uses PSETs
Reset PRM (prmconfig -r), then after the online cell operation has completed, restart
PRM management (prmconfig -ie [-f file]).
For more information on online cell operations, see parolrad(1M).
Compatibility with Bastille and firewalls
By default, xprm controls PRM on remote systems through port 9610 on the remote systems.
If your network or the remote systems use a firewall or if you are using the HP-UX Bastille
product on the remote systems, it is likely that communications on this port are being blocked.
To use xprm in your environment, your options include:
• Specifically allowing port 9610 or another port to be open to incoming connections. If you
use a port other than 9610, be sure to restart prm3d to listen on the new port on each
remote system; also, have xprm connect to the new port.
• Using SecureShell (ssh) to connect to the locked-down system and running xprm if you do
not want to open a port. (SecureShell must be installed on the system that you are on and
on the system to which you want to connect.)