HP PRM Version C.03.02.xx Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

PRM Release Notes
Compatibility information and installation requirements
Chapter 112
Step 9. Restart WLM if it was running before the PRM upgrade/installation:
# /opt/wlm/bin/wlmd -A
Step 10. Restart MeasureWare if it was running before the PRM upgrade/installation:
# /sbin/init.d/mwa start
PRM is installed in /opt/prm/. PRM manpages are also installed in /opt/prm/.
NOTE If you have made any modifications to your /etc/rc.config.d/prm file and the
corresponding file being shipped with the PRM being installed has changed, the
file /var/adm/sw/swagent.log will note a conflict. If there is a conflict, merge the
file /usr/newconfig/etc/rc.config.d/prm with your /etc/rc.config.d/prm file.
Changes in the file shipped with PRM are due to the introduction of new
variables or changes in the default values for existing variables.
Starting with PRM C.02.01, the /usr/newconfig/etc/rc.config.d/prm file includes
several new variables: PRM_CONFIG_FILE, PRM_INT_APPL, PRM_INT_MEM,
PRM_LOG_APPL, and PRM_LOG_MEM.
Required patches
The patches needed to use PRM Version C.03.02.xx are discussed below.
For the latest information on patches, visit the “patches” page available from
http://www.hp.com/go/prm/.
The patches below—or their successors—may be available in patch bundles. Obtain patches
and patch bundles from http://itrc.hp.com or from the quarterly HP-UX software update
release CDs.