HP PRM Version C.03.02.xx Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

PRM Release Notes
Compatibility information and installation requirements
Chapter 110
Installation procedure
To install your software:
NOTE If the PRM-Sw-Krn.PRM-KRN fileset is not installed or it is installed but its
revision is older than the current revision (C.01.04), the current revision will be
installed, causing a reboot.
Step 1. Shut down any versions of PRM, WLM, and GlancePlus that are already installed.
Having these products running can prevent the proper update of files that are in
use. Be sure to shut down WLM (wlmd -k), its configuration wizard, wlmgui, PRM
(prmconfig -r), xprm, and GlancePlus—if any of them are running.
Step 2. Evaluate whether to upgrade any WLM version that is installed, as explained in
“Upgrading or installing PRM before upgrading WLM from C.03.00 or earlier can
cause WLM to fail swverify checks” on page 26.
Step 3. Shut down MeasureWare if it is running:
# /sbin/init.d/mwa stop
Step 4. Shut down HP Integrity Virtual Machines if it is running:
# /sbin/init.d/hpvm stop
PRM cannot run on a host used as a virtual machines host. However, you can use
PRM inside virtual machines.
Step 5. Start the SD-UX swinstall command. It will invoke a user interface to lead you
through the installation.
Step 6. Load product B3835DA and install patches from the section “Required patches” on
page 12.