HP PRM Version C.03.01 Release Notes for HP-UX 11i v1 and HP-UX 11i v2

PRM Release Notes
Known problems and workarounds
Chapter 1 11
Workaround
This issue is due to a permissions problem. Change permissions as shown
below:
# chmod 755 /dev/vx
If you are interested in the status of this issue, contact your HP support
representative regarding CR# JAGae90306 (for HP-UX 11i v1) or
CR# JAGae73866 (for HP-UX 11i v2).
libprmext “not removed” on PRM upgrade
Issue
When upgrading your version of PRM, you may see the following message in
/var/adm/sw/swagent.log:
File “/opt/prm/lib/hpux32/libprmext.so.2” could not be
removed. It was renamed and added to the cleanup file
“/var/adm/sw/cleanupfile”.
This message is generated by swinstall when the libprmext file is busy,
most likely because HP-UX Workload Manager (WLM), GlancePlus, or
MeasureWare were running when a PRM upgrade started.
Workaround
If you do see this message:
1. Use the fuser command to determine what processes are using
libprmext:
# fuser /opt/prm/lib/libprmext.sl
# fuser /opt/prm/lib/hpux32/libprmext.so
2. Stop any processes that are using libprmext. (The “Installation
procedure” given later indicates how to stop WLM and MeasureWare.)
If you are unable to stop the processes, skip the next step and reboot.
3. Reset PRM:
# prmconfig -r