HP PRM Version C.03.00 Release Notes for HP-UX 11i v1 and HP-UX 11i v2

PRM Release Notes
Compatibility information and installation requirements
Chapter 1 13
Disk and memory requirements
PRM Version C.03.00 requires:
• 7 Mbytes of disk space
• 2 Mbytes of memory (18 Mbytes if using xprm GUI)
Installation procedure
Read this entire document and any other release notes or README files you have before you
begin an installation.
To install your software:
NOTE If the PRM-Sw-Krn.PRM-KRN fileset is not installed or it is installed but its
revision is older than the current revision (C.01.03), the current revision will be
installed, causing a reboot.
Step 1. Shut down any versions of PRM, WLM, and GlancePlus that are already installed.
Having these products running can prevent the proper update of files that are in
use. Be sure to shut down WLM (wlmd -k), its configuration wizard, wlmgui, PRM
(prmconfig -r), xprm, and GlancePlus—if any of them are running.
Step 2. Shut down MeasureWare if it is running:
# /usr/sbin/init.d/mwa stop
Step 3. Start the SD-UX swinstall command. It will invoke a user interface to lead you
through the installation.
Step 4. Load product B3835DA and install patches from the section “Required patches” on
page 15.