HP PRM Version C.02.03 Release Notes for HP-UX 11i V1.0 and HP-UX 11i V2.0

PRM Release Notes
Compatibility information and installation requirements
Chapter 1 13
PRM is installed in /opt/prm/. PRM man pages are also installed in /opt/prm/.
NOTE If you have made any modifications to your /etc/rc.config.d/prm file and the
corresponding file being shipped with the PRM being installed has changed, the
file /var/adm/sw/swagent.log will note a conflict. If there is a conflict, merge the
file /usr/newconfig/etc/rc.config.d/prm with your /etc/rc.config.d/prm file.
Changes in the file shipped with PRM are due to the introduction of new
variables or changes in the default values for existing variables.
Starting with PRM C.02.01, the /usr/newconfig/etc/rc.config.d/prm file includes
several new variables: PRM_CONFIG_FILE, PRM_INT_APPL, PRM_INT_MEM,
PRM_LOG_APPL, and PRM_LOG_MEM.
Recommended patches
The patches needed to use PRM Version C.02.03 are discussed below.
For the latest information on patches, visit the “patches” page available from
http://www.hp.com/go/prm/.
The patches below—or their successors—may be available in Support Plus Quality Packs.
Using these Quality Packs, you can install numerous patches at once. The Quality Pack patch
bundles are available from http://software.hp.com as well as on the quarterly HP-UX software
update release CDs.
Patches for the PRM GUI, xprm
For information on patches needed for using xprm, see the “patches” section of:
http://www.hp.com/go/java
Look for patches that are required or recommended for Java JRE 1.4.
For HP-UX 11i V1.0, apply patch PHCO_29109 to address a pthread library issue.
HP-UX 11i V2.0 (B.11.23) patches
Install the patch bundle BUNDLE11i. Any version of this bundle is acceptable.