Command Reference Guide

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1/!!!intro.1
________________________________________________________________
___ ___
g
genxlt(1) genxlt(1)
This is an example of the input_file:
#What: CodesetA to CodesetB: version 1.0
#Galley: 0xffff
# the conversion data is as follows:
0x01 0x01
0x02 0x42
...
0xff87 0x4567
...
etc.
WARNINGS
Because genxlt will write over the existing table, it is wise to save the existing table into another file
before using genxlt.
Warnings are not given for incorrect data in the input_file.
You must have super-user privileges to install files in /usr/lib/nls/iconv/tables.
FILES
/usr/lib/nls/iconv/tables
All tables must be installed in this directory.
SEE ALSO
dmpxlt(1), iconv(1), iconv(3C).
STANDARDS COMPLIANCE
genxlt: XPG4 tables
HP-UX Release 11i: December 2000 − 2 − Section 1−−317
___
___