Command Reference Guide

__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man1/!!!intro.1
________________________________________________________________
___ ___
d
dos2ux(1) dos2ux(1)
NAME
dos2ux, ux2dos - convert ASCII file format
SYNOPSIS
dos2ux file...
ux2dos file...
DESCRIPTION
dos2ux and ux2dos read each specified file in sequence and write it to standard output, converting to
HP-UX format or to DOS format, respectively. Each file can be either DOS format or HP-UX format for either
command.
A DOS file name is recognized by the presence of an embedded colon (:) delimiter; see dosif(4) for DOS file
naming conventions.
If no input file is given or if the argument - is encountered, dos2ux and ux2dos read from standard
input. Standard input can be combined with other files.
EXAMPLES
Print file myfile on the display:
dos2ux myfile
Convert file1 and file2 to DOS format then concatenate them together, placing them in file3.
ux2dos file1 file2 > file3
RETURN VALUE
dos2ux and ux2dos return 0 if successful or 2 if the command failed. The only possible failure is the
inabilityto open a specified file, in which case the commands print a warning.
WARNINGS
Command formats resembling:
dos2ux file1 file2 > file1
overwrite the data in file1 before the concatenation begins, causing a loss of the contents of
file1.
Therefore, be careful when using shell special characters.
SEE ALSO
doschmod(1), doscp(1), dosdf(1), dosls(1), dosmkdir(1), dosrm(1), dosif(4).
Section 1−−186 − 1 − HP-UX Release 11i: December 2000
___
___