HP AD278A and AD279A PCI Multiplexer Release Notes HP-UX 11i v2 and HP-UX 11i v3 (5900-2200, February 2012)

Table 3 Defects fixed
Defect DescriptionDefect ID
CRTS is reset on pci_mux1 direct device open, when pci_mux and asio0 do
not reset CRTS. This is resolved in the current release.
QXCR1001184081
In pci_mux1, ch_callin/ch_callout may become negative. This is resolved in
the current release.
QXCR1001194090
If lock mismatch in delayed, hangup may cause pci_mux1 ports to hang.
This is resolved in the current release.
QXCR1001194093
The MTNOACTIVITY timer is in seconds instead of minutes. This is resolved
in the current release.
QXCR1001194100
Interoperability information and installation requirements
This section provides information on interoperability, software, and hardware requirements for
installing the current version of the AD278A/AD279A PCI MUX product on HP-UX 11i v2 and
HP-UX 11i v3.
Interoperability information
The non-RoHS (A6748A/A6749A) adapters and RoHS (AD278A/AD279A) PCI MUX adapters
can coexist on a system. The RoHS adapters cannot be connected to non-RoHS cables, connectors,
or port modules. The RoHS cables, connectors, or port modules cannot be connected to non-RoHS
adapters.
For more information about non-RoHS (A6748A/A6749A) and RoHS (AD278A/AD279A) RJ-45
connectors pin-out information, see the HP AD278A and AD279A PCI Multiplexer Support Guide.
Hardware requirements
Table 4 lists the platforms that support AD278A/AD279A PCI MUX serial adapters on HP-UX 11i
v2 and HP-UX 11i v3 systems.
Table 4 AD278A/AD279A PCI MUX Serial Adapters
ClassServer/Workstation
PA-RISCrp3410
PA-RISCrp3440
PA-RISCrp4440
PA-RISCrp7410
PA-RISCrp7420
Itanium-basedrx2620
Itanium-basedrx4640
Itanium-basedrx5670
Itanium-basedrx7620
Itanium-basedrx8620
For latest information about the platform support, see Support Matrix document at http://
www.docs.hp.com/en/netcom.html#Multiplexers.
6 Announcement