STM Online Help: xstm Online Help (graphical interface)

Select this radio button if you want to define the length of time the exercise test procedure is to run (in minutes), before
it halts.
Loop Continuously
Select this radio button if you want the exercise test procedure to repeat until you halt or abort it.
Behavior on Errors
Using the radio buttons associated with this heading, you can define the way in which you want a specified tool to
behave on encountering a "soft" error; e.g., a recoverable read error (hard errors, by contrast, cause the tool to create a
failure log and exit, no matter how this option is set).
You may choose to exit the tool on finding an error, you may terminate test execution after a certain number of errors
have been encountered, or you may choose to continue tool execution in spite of encountering an error.
Exit on Error
Select this radio button if you want a specified tool to exit on encountering an error.
Errors Allowed before Test Termination
Select this radio button if you want a specified tool test to terminate when a certain number of "soft" errors (for
example, recoverable read errors) are encountered.
Test Coverage
Using the radio buttons associated with this heading, you can specify either maximum, moderate, or minimum test
coverage.
Maximum
Select this radio button when you want to exercise system hardware as thoroughly you can. Note that selecting this
level of coverage may require significantly longer execution time for some devices.
Medium
Select this radio button when you want to exercise system hardware with a moderate degree of confidence.
Minimum
Select this radio button when you want to exercise system hardware, but only to the minimum standard level of
adequacy and acceptance.
Generate Tool Activity Log
Click on this checkbox if you want to keep a log of all actions performed by a selected tool. The associated radio
buttons will let you specify whether or not you want to log only errors, errors and warnings, or errors, warnings, and
information.