STM Online Help: mstm Online Help (menu interface)

Execution Control
You can control execution of future diagnose commands with the three checkboxes associated with this
heading:
Iterations to Loop -- number of times to repeat diagnose procedure
Execution Time Limit, in Minutes -- how long (in minutes) to run test
Loop Continuously -- repeat diagnose procedure until it is halted or aborted
Iterations to Loop
Put an "x" in this checkbox if you want to define the number of times the diagnose test procedure is to be
repeated before it halts.
Execution Time Limit, in Minutes
Put an "x" in this checkbox if you want to define the length of time the diagnose test procedure is to run
(in minutes), before it halts.
Loop Continuously
Put an "x" in this checkbox if you want the diagnose test procedure to repeat until you halt or abort it.
Error Isolation Level
Using the checkboxes associated with this heading, you can choose to diagnose down to either the Field
Replaceable Unit (FRU) or component level.
Field Replaceable Unit (FRU)
Put an "x" in this checkbox to diagnose down to the level of a Field Replaceable Unit (FRU).
Component
Put an "x" in this checkbox to diagnose down to the component level.
Test Coverage
Using the checkboxes associated with this heading, you can specify either maximum, moderate, or
minimum test coverage.
Maximum
Put an "x" in this checkbox when you want to diagnose system hardware as thoroughly you can. Note that
selecting this level of coverage may require significantly longer execution time for some devices.
Medium
Put an "x" in this checkbox when you want to diagnose system hardware with a moderate degree of
confidence.