STM Online Help: mstm Online Help (menu interface)

Report Errors, Warnings, and Information
Put an "x" in this checkbox if you want to keep a log of all errors encountered by a selected tool, and all
warnings and information messages generated as a result of tool activity.
User Queries
You may select whether to interact with a specified tool, or to use the tool's default information values,
depending upon which of the following options you select:
Allow
Disallow (Non-Destructive)
Disallow (Destructive)
Allow
When you select this options, you can interact with a specified tool, instead of using the tool's default
information values.
Disallow (Non-Destructive)
When you select this option, you can disable the "User Queries" function, and run the tool both non-
interactively and non-destructively.
Disallow (Destructive)
When you select this option, you will perform DESTRUCTIVE tests non-interactively.
You will see the following WARNING message displayed:
WARNING: You have set the User Queries option to enable destructive
tests.
-----------------------------------------------------------------------------
When User Queries is set to 'Disallow: allow destructive operations,'
some tools will perform DESTRUCTIVE tests. For example, ALL DATA on
unmounted disk drives WILL BE DESTROYED. The 'Disallow: allow
destructive operations' setting of the User Queries option is intended
for manufacturing tests only. Use of this setting is highly
discouraged.
-----------------------------------------------------------------------------
To change the User Queries option, you must re-enter the
(verify / exercise / diagnose) options menu.
Top
Diagnose Options
Use this function to configure the options which will be used for subsequently executing diagnostic tools,
including:
Controlling execution time/loop limits
Defining error isolation level
Defining test coverage
Defining the contents of the Act Log
Allowing/disallowing user queries