STM Online Help: mstm Online Help (menu interface)

If you select this checkbox, the "Run Command File" command will abort execution on finding an error.
Top
Tool Options
Use this menu to access the set of functions which allows you to define options for tools and utilities and
how to launch them. There are eight Tool Options functions:
Information Options: Configure information tool options
Verify Options: Configure verification tool options
Diagnose Options: Configure diagnostic tool options
Exercise Options: Configure exerciser tool options
FWupdate Options: Configure firmware update options
Expert Tool Options: Configure expert tools options
Utility Options: Configure utility options
Launch Options: Enable/define test and debug options
Top
Information Options
Use this function to configure the options which will be used for subsequently executed information tools,
including:
Defining the contents of the Act Log
Allowing/disallowing user queries
Generate Tool Activity Log
Select this checkbox if you want to keep a log of all actions performed by a selected tool. The associated
checkboxes will let you specify whether or not you want to log only errors, errors and warnings, or errors,
warnings, and information.
Once you have selected this checkbox, you may move to the "Allow User Queries" checkbox, or hit "OK".
Report Only Errors
Put an "x" in this checkbox if you want to keep a log of all errors encountered by a selected tool.
Report Only Errors and Warnings
Put an "x" in this checkbox if you want to keep a log of all errors encountered by a selected tool, and all
warnings generated as a result of tool activity.
Report Errors, Warnings, and Information
Put an "x" in this checkbox if you want to keep a log of all errors encountered by a selected tool, and all
warnings and information messages generated as a result of tool activity.