STM Online Help: mstm Online Help (menu interface)

Latest Logs: Display the latest tool logs
Tool Mgmt: Menu to abort/suspend/resume tools and utilities
See Tools Menu for help on running these tools, for logging help, and for additional information.
Top
Information
Use this function to create a log of information specific to each selected device, which has an information
function, including:
The product identifier
A description of the device
The hardware path to the device
The vendor
Typically, the firmware revision code, if firmware is present in the device(s) selected, will also be
displayed.
The information tool runs on all selected devices that are not currently busy.
When the tool exits, returning a "SUCCESSFUL" or "WARNING" status, you should consult the
Information Log, Fail Log, and/or Act Log for information retrieved by the tool about the hardware.
Top
Verify
Use this function to verify all selected devices for which a verifier function exists. The purpose of the
verification procedure is to ensure as quickly as possible that the target hardware is usable, and that you
will be successful in using the device. Verifiers don't tend to isolate down to the FRU level, nor are they
generally interactive.
To verify a selected device or devices, the target device(s) must not only support verification, it must also
currently be idle.
When you first start to verify a device(s), the device(s) state on the device map will be changed to
"RUNNING".
If the operation requires you to interact with the interface, the device state will change to "Query Pending".
If the UI started the tool, the query will display automatically. If the UI did not start the tool, you must
select the Display Query function to display the query.
Once the verify operation has completed, this state will change to "Success", "WARNING", or
"FAILURE", as appropriate.
You should then consult the Fail Log for information on tool failures, and the Act Log for all other tool
activity information.
Top