STM Online Help: cstm Online Help (command-line interface)

UtilOptions
Syntax: utiloptions | uop [gentactlog {yes|no}] [reporterrors | reportwarnings | reportinfo]
Use this command to configure the options which will be used for subsequently executing utility tools, including:
Defining the contents of the InfoActLog
Generate Tool Activity Log
Enter "y" at this prompt, if you want to keep a log of all actions performed by a selected tool. The succeeding prompts
will let you specify whether or not you want to log only errors, errors and warnings, or errors, warnings, and
information.
Report Only Errors
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool.
Report Only Errors and Warnings
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings
generated as a result of tool activity.
Report Errors, Warnings, and Information
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings and
information messages generated as a result of tool activity.
Top
LaunchOptions
Syntax: launchoptions | lop [debugmode {yes|no}] [sourcedir {<path to source code}] [motifflag {yes|no}] [display
{<address of display machine}]
[testmode {yes|no}] [filename {<systest input file}]
Use this command for assistance in debugging and testing tools developed for cstm.
The dialog contains two checkboxes to enable Debug and Test Modes.
NOTE: Both modes may be enabled at the same time.
Debug mode is used to provide information for the Distributed Debugging Environment (DDE) debugger.
Test mode is used to specify a systest() input file.
Debug Mode
Enter "y" at this prompt when you want to provide information for the Distributed Debugging Environment (DDE)