STM Online Help: cstm Online Help (command-line interface)

You may select whether to interact with a specified tool, or to use the tool's default information values, depending
upon which of the following commands you enter:
Allow
Disallow (Non-Destructive)
Disallow (Destructive)
Allow
When you enter this command, you can interact with a specified tool, instead of using the tool's default information
values.
Disallow (Non-Destructive)
When you enter this command, you can disable the "User Queries" function, and run the tool both non-interactively
and non-destructively.
Disallow (Destructive)
When you enter this command, you will perform DESTRUCTIVE tests non-interactively.
You will see the following WARNING message displayed:
WARNING: You have set the User Queries option to enable destructive
tests.
-----------------------------------------------------------------------------
When User Queries is set to 'Disallow: allow destructive operations,'
some tools will perform DESTRUCTIVE tests. For example, ALL DATA on
unmounted disk drives WILL BE DESTROYED. The 'Disallow: allow
destructive operations' setting of the User Queries option is intended
for manufacturing tests only. Use of this setting is highly
discouraged.
-----------------------------------------------------------------------------
To change the User Queries option, you must re-enter the
(verify / exercise / diagnose) options menu.
Top
FWUpdateOptions
Syntax: fwupdateoptions | fop [file {<update file>}] [gentactlog {yes|no}] [reporterrors | reportwarnings | reportinfo]
Use this command to configure the options which will be used for subsequently executing firmware update tools,
including:
Selecting/applying update directory/file filters
Defining the contents of the InfoActLog
Update File
You enter the path (i.e., directory) and filename of the file from which you wish to load the updated firmware
information. Hit "Return" and the firmware will be updated from that file whenever the "Firmware Update" command
is executed.
Generate Tool Activity Log