STM Online Help: cstm Online Help (command-line interface)

Enter "medium" when you want to diagnose system hardware with a moderate degree of confidence.
Minimum
Enter "minimum" when you want to diagnose system hardware, but only to the minimum standard level of adequacy
and acceptance.
Generate Tool Activity Log
Enter "y" at this prompt, if you want to keep a log of all actions performed by a selected tool. The succeeding prompts
will let you specify whether or not you want to log only errors, errors and warnings, or errors, warnings, and
information.
Report Only Errors
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool.
Report Only Errors and Warnings
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings
generated as a result of tool activity.
Report Errors, Warnings, and Information
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings and
information messages generated as a result of tool activity.
User Queries
You may select whether to interact with a specified tool, or to use the tool's default information values, depending
upon which of the following commands you enter:
Allow
Disallow (Non-Destructive)
Disallow (Destructive)
Allow
When you enter this command, you can interact with a specified tool, instead of using the tool's default information
values.
Disallow (Non-Destructive)
When you enter this command, you can disable the "User Queries" function, and run the tool both non-interactively
and non-destructively. This option is intended for manufacturing use.
Disallow (Destructive)
When you enter this command, you will perform DESTRUCTIVE tests non-interactively.
You will see the following WARNING message displayed: