STM Online Help: cstm Online Help (command-line interface)

Controlling execution time/loop limits
Defining error isolation level
Defining test coverage
Defining the contents of the InfoActLog
Allowing/disallowing user queries
Execution Control
You can control execution of future diagnose commands with the three options associated with this heading:
Iterations to Loop -- number of times to repeat diagnose procedure
Execution Time Limit, in Minutes -- how long (in minutes) to run test
Loop Continuously -- repeat diagnose procedure until it is halted or aborted
Iterations to Loop
Enter "iterations" if you want to define the number of times the diagnose test procedure is to be repeated before it halts.
Execution Time Limit, in Minutes
Enter "time" if you want to define the length of time the diagnose test procedure is to run (in minutes), before it halts.
Loop Continuously
Enter "continuously" if you want the diagnose test procedure to repeat until you halt or abort it.
Error Isolation Level
Using the options associated with this heading, you can choose to diagnose down to either the Field Replaceable Unit
(FRU) or component level.
Field Replaceable Unit (FRU)
Enter "fru" to diagnose down to the level of a Field Replaceable Unit (FRU).
Component
Enter "component" to diagnose down to the component level.
Test Coverage
Using the options associated with this heading, you can specify either maximum, moderate, or minimum test coverage.
Maximum
Enter "maximum" when you want to diagnose system hardware as thoroughly you can. Note that selecting this level of
coverage may require significantly longer execution time for some devices.
Medium