STM Online Help: cstm Online Help (command-line interface)

Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings and
information messages generated as a result of tool activity.
User Queries
You may select whether to interact with a specified tool, or to use the tool's default information values, depending
upon which of the following commands you enter:
Allow
Disallow (Non-Destructive)
Disallow (Destructive)
Allow
When you enter this command, you can interact with a specified tool, instead of using the tool's default information
values.
Disallow (Non-Destructive)
When you enter this command, you can disable the "User Queries" function, and run the tool both non-interactively
and non-destructively.
Disallow (Destructive)
When you enter this command, you will perform DESTRUCTIVE tests non-interactively.
You will see the following WARNING message displayed:
WARNING: You have set the User Queries option to enable destructive
tests.
-----------------------------------------------------------------------------
When User Queries is set to 'Disallow: allow destructive operations,'
some tools will perform DESTRUCTIVE tests. For example, ALL DATA on
unmounted disk drives WILL BE DESTROYED. The 'Disallow: allow
destructive operations' setting of the User Queries option is intended
for manufacturing tests only. Use of this setting is highly
discouraged.
-----------------------------------------------------------------------------
To change the User Queries option, you must re-enter the
(verify / exercise / diagnose) options menu.
When you enter this command, you will perform DESTRUCTIVE tests non-interactively. This means that ALL DATA
on unmounted disks WILL BE DESTROYED. This option is intended for manufacturing purposes only. It is highly
recommended that you either use the Allow or Disallow (Non-Destructive) option instead.
Top
DiagOptions
Syntax: diagoptions | dop [execctrl] [iterations {<loop count>} | time {<minutes>} | continuously] [isolation] [fru |
component] [testcoverage] [maxcoverage | medcoverage | mincoverage] [gentactlog {yes|no}] [reporterrors |
reportwarnings | reportinfo] [queries] [queryallow | querynondes | querydes]
Use this command to configure the options which will be used for subsequently executing diagnostic tools, including: