STM Online Help: cstm Online Help (command-line interface)

For utilities which are not in the "abort pending" state, you should first try AbortUtil.
Top
Options Category
The Options Category includes ten commands:
InfoOptions: Configure information tool options
VerOptions: Configure verification tool options
DiagOptions: Configure diagnostic tool options
ExerOptions: Configure exerciser tool options
FWUpdateOptions: Configure firmware update options
ExpOptions: Configure expert tools options
UtilOptions: Configure utility options
LaunchOptions: Enable/define test and debug options
MapOptions: Configure device map options
GeneralOptions: Configure general interface options
Top
InfoOptions
Syntax: infooptions | iop [gentactlog {yes | no}] [reporterrors | reportwarnings | reportinfo] [queries {yes | no}]
Use this command to configure the options which will be used for subsequently executed information tools, including:
Defining the contents of the InfoActLog
Allowing/disallowing user queries
Generate Tool Activity Log
Enter "y" at this prompt, if you want to keep a log of all actions performed by a selected tool. The succeeding prompts
will let you specify whether or not you want to log only errors, errors and warnings, or errors, warnings, and
information.
Report Only Errors
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool.
Report Only Errors and Warnings
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings
generated as a result of tool activity.
Report Errors, Warnings, and Information
Enter "y" at this prompt, if you want to keep a log of all errors encountered by a selected tool, and all warnings and
information messages generated as a result of tool activity.