STM Online Help: cstm Online Help (command-line interface)

executed. You will be shown a list of non-suspended interactive support tools, and then you choose the one you want
connected to your display. This command is invalid if there are no currently non-escaped interactive support tools.
Support Tool to Attach
Use this command to select an interactive support tool after the "Attach" comand has been entered. You will be shown
a list of non-suspended interactive support tools, and then you choose the one you want connected to your display.
This command is invalid if there are no currently non-escaped interactive support tools.
Enter "OK" to proceed, and "Cancel" if you decide not to continue with execution of the "Attach" command.
No Support Tool Available
There are no currently non-suspended interactive tools available. You cannot attach the UI to an interactive tool at this
time.
Select "OK" to proceed.
Top
Wait
Syntax: wait | wait
Use this command to cause the user interface to wait until all invoked support operations have been completed before
continuing. If a tool is in the "Starting", "Running", "Delayed" or "Hung" state, it is considered busy.
This command is automatically inserted after a tool is run while recording commands, to prevent operations which
were executed sequentially at record time from being attempted simultaneously at playback time.
Note: the wait will exit if the general option "Terminate Wait Command If Any Tool Not Successful" is set and any
tool is in the "Failed" or "Warning" state.
Top
Killtool
Syntax: killtool | klt
Use this command to kill a tool which is in the "abort pending" state, but which doesn't manage to abort properly (see
also Killutil).
For tools which are not in the "abort pending" state, you should first try AbortTool.
Killutil
Syntax: killutil | klu
Use this command to kill a utility which is in the "abort pending" state, but which doesn't manage to abort properly
(see also
Killtool).