STM Online Help: cstm Online Help (command-line interface)

Utility Execution
This dialog allows you to specify which utility's log you wish to access, either the last utility executed by the UI, or the
last utility executed by the UI on a particular device.
Most Recent Utility Executed
Enter "utility" or its index number if you want to view the Tool Activity Log for the most recently executed utility on
the Unit Under Test (UUT), without specifying a particular device.
To select the utility, enter the appropriate utility name or index number at the prompt; then enter "ok".
Most Recent Utility Executed on Device
Enter "device" or its index number if you want to view the Tool Activity Log for the most recently executed utility on
a particular device.
To select the device, enter the appropriate device address at the "Select Device" prompt; then enter "ok".
Select Utility
Select a utility to run from the list displayed, then enter "OK" to proceed.
If you choose not to continue with utility selection and execution, enter "Cancel" instead.
Utility Information
This dialog allows you to select a utility from a list, and get more information about it.
Select Utility Info
Select the name of a utility from the list displayed to access more information about the selected utility. Enter "OK" to
proceed. If you decide you do not wish to access the utility's information screen at this time, enter "Cancel" instead.
Top
UtilActLog
Syntax: utilactlog | ual [utility {<utility name>} | device {<device num>}]
Use this command to review the log which contains details concerning the most recent invocation of a Utility Tool on
all selected devices. The command is valid when a Tool Activity Log for the Utility Tool exists for the selected
device(s).
Top
UtilFailLog
Syntax: utilfaillog | ufl [utility {<utility name>} | device {<device num>}]