STM Online Help: cstm Online Help (command-line interface)

is to stress the target hardware in a way that meets or exceeds the stress typically placed on that hardware in the
customer environment. Exercisers are not generally interactive.
To exercise a selected device or devices, the target device(s) must not only support exercise operations, it must also
currently be idle.
When you first start to exercise a device(s), the device(s) state on the device map will be changed to "RUNNING".
If the operation requires you to interact with the interface, the device state will change to "Query Pending". If the UI
started the tool, the query will display automatically. If the UI did not start the tool, you must type DisplayQuery to
display the query.
Once the exercise operation has completed, this state will change to "Success", "WARNING", or "FAILURE", as
appropriate.
You should then consult the ExerFailLog for information on tool failures, and the ExerActLog for all other tool activity
information.
Top
ExerActLog
Syntax: exeractlog | eal
Use this command to review the log which contains details concerning the most recent invocation of an Exercise Tool
on all selected devices. The command is valid when a Tool Activity Log for an Exercise Tool exists for the selected
device(s).
Top
ExerFailLog
Syntax: exerfaillog | efl
Use this command to review the log which contains details concerning failures encountered during the most recent
execution of an Exercise Tool on all selected devices. The command is valid when a Tool Failure Log for an Exercise
Tool exists for the selected device(s).
Top
ExerInfo
Syntax: exerinfo | einf
Use this command to display help information unique to the Exercise Tools for the selected devices. It may always be
run, because it does not access the device to obtain its information.
Top
FirmwareUpdate