STM Online Help: cstm Online Help (command-line interface)

be idle.
When you first start to diagnose a device(s), the device(s) state on the device map will be changed to "RUNNING".
If the operation requires you to interact with the interface, the device state will change to "Query Pending". If the UI
started the tool, the query will display automatically. If the UI did not start the tool, you must type DisplayQuery to
display the query.
Once the diagnose operation has completed, this state will change to "Success", "WARNING", or "FAILURE", as
appropriate.
You should then consult the DiagFailLog for information on tool failures, and the DiagActLog for all other tool activity
information.
Top
DiagActLog
Syntax: diagactlog | dal
Use this command to review the log which contains details concerning the most recent invocation of a Diagnose Tool
on all selected devices. The command is valid when a Tool Activity Log for a Diagnose Tool exists for the selected
device(s).
Top
DiagFailLog
Syntax: diagfaillog | dfl
Use this command to review the log which contains details concerning failures encountered during the most recent
execution of a Diagnose Tool on all selected devices. The command is valid when a Tool Failure Log for a Diagnose
Tool exists for the selected device(s).
Top
DiagInfo
Syntax: diaginfo | dinf
Use this command to display help information unique to the Diagnose Tools for the selected devices. It may always be
run, because it does not access the device to obtain its information.
Top
Exercise
Syntax: exercise | exc
Use this command to exercise all selected devices for which an exerciser exists. The purpose of the exerciser procedure