STM Online Help: cstm Online Help (command-line interface)

started the tool, the query will display automatically. If the UI did not start the tool, you must type DisplayQuery to
display the query.
Once the verify operation has completed, this state will change to "Success", "WARNING", or "FAILURE", as
appropriate.
You should then consult the InfoFailLog for information on tool failures, and the InfoActLog for all other tool activity
information.
Top
VerActLog
Syntax: veractlog | val
Use this command to review the log which contains details concerning the most recent invocation of a Verify Tool on
all selected devices. The command is valid when a Tool Activity Log for a Verify Tool exists for the selected
device(s).
Top
VerFailLog
Syntax: verfaillog | vfl
Use this command to review the log which contains details concerning failures encountered during the most recent
execution of a Verify Tool on all selected devices. The command is valid when a Tool Failure Log for a Verify Tool
exists for the selected device(s).
Top
VerInfo
Syntax: verinfo | vinf
Use this command to display help information unique to the Verify Tools for all the selected devices. It may always be
run, because it does not access the device to obtain its information.
Top
Diagnose
Syntax: diagnose | dgn
Use this command to diagnose all selected devices for which a diagnostic exists. The purpose of the diagnostic
procedure is to test the target hardware as completely as possible, and if any errors are found, to isolate to the FRU
level. Isolation to the component level is also provided, when possible. Diagnostic modules are not generally
interactive.
To diagnose a selected device or devices, the target device(s) must not only support diagnostics, it must also currently