STM Online Help: cstm Online Help (command-line interface)

Select Matching Devices: Choose all devices of the same type
Select Matching Products: Choose all devices of the same product
Select Devices Above: Choose all devices above the selected devices
Select Devices Below: Choose all devices below the selected devices
Unselect: Deselect a single device
UslClass: Deselect several devices at the same time
UnselAll: Deselect all devices in the hardware map
Set Filter: Set device map filter
Clear Filter: Clear device map filter
Top
CurrDevStatus
Syntax: currdevstatus | cds
Use this command to display all known information for the selected devices, including current status, and to receive
suggestions on further actions which you might take at this point. The data displayed for each device includes the
following:
A description of the device
The hardware path, specifying the address of the hardware components leading to the device
The device type (e.g, disk, tape)
The device qualifier (e.g., SCSI, CS80)
The most recent tool executed/executing on the device
Exit status of the most recent tool run
The current status of the device
Recommended user action
The "Current Device Status" may be run at any time, even if the device is currently busy, as it does not access the
device to obtain its information.
When a utility is executing, the current status field also shows the process number for the utility.
The recommended action field is used to suggest what action you might want to take next. For example, in the event
of a tool failure, you might see a message suggesting that you examine the InfoActLog and the InfoFailLog.
Top
ClearToolStatus
Syntax: cleartoolstatus | cts
Use this command to reset the state of all selected devices which do not have a currently running support tool process
to "Untested". This command also removes the InfoActLog and the InfoFailLog for all devices.
Top
Select
Syntax: select | sel {[-] all | device {[-] all | <device num>|<device num> - <device num>}| path {[-] all | <path